freaktmp
Expert
- Joined
- 20 Απρ 2009
- Μηνύματα
- 9.900
- Αντιδράσεις
- 10.904
Στο νεο hardware revision (εκδοση C) υποστηριζεται πλεον η δυνατοτητα εγγραφης σε Amiga!
Απο το readme του νεου firmware update:
Απο το readme του νεου firmware update:
Για οσους θελουν μαθουν περισσοτερα για τον HxC Floppy emulator μπορουν να δουν το τρεχων thread μας, το site του σχεδιαστη και το site του κατασκευαστη. Δεν εχει ακομα ανακοινωθει αν θα ειναι διαθεσιμο προς πωληση το rev. C, εστειλα ενα mail στο παλικαρι που το φτιαχνει και θα δουμε τι θα μας πει.22/08/2010: Firmware SD HxCFloppyEmulator v1.3.0.0- Amiga Write support added :
Note to the Revision B PCB owners :
To activate this new features you need to add a Microchip 23K256 SPI SRAM chip and 4 resistors.
The connection to do is :
23K256 pin 1 -> 220ohms resistor -> PIC18F4620 pin 22
23K256 pin 5 -> 220ohms resistor -> PIC18F4620 pin 27
23K256 pin 6 -> 220ohms resistor -> PIC18F4620 pin 28
23K256 pin 2 -> 220ohms resistor -> PIC18F4620 pin 29
23K256 pin 8 & 7 -> VCC3.3V (this voltage can be found at the capacitor under the sdcard connector or at the output of the regulator)
23K256 pin 4 -> GND
23K256 pin 3 -> Not connected.
(a 100nF capacitor is also recommended at the pin 8 of the 23K256)
After this modification you should see the message "SRAM OK" at power up.